Steel structure hotel is a fabricated building, which adopts the mature steel structure fabricated system of Canglong group.

It has the advantages of fast construction speed and short cycle. During the construction of steel structure hotel, the construction waste is reduced by 70%, and the on-site wet operation is less, thus reducing the water consumption, which is in line with the concept of green environmental protection.

In addition, the wall adopts ALC strip, which is anti- moisture and improves the convenience of on-site assembly and installation.

The bathroom adopts the integrated bathroom. The assembly time is only 4 hours, which greatly reduces the assembly time.

Steel structure overview

The structural is mainly assembled by steel plate, hot-rolled steel or cold-formed thin-walled steel.

Compared with the traditional building structure, the steel structure house has many superior characteristics:

1. Good ductility and good seismic performance;

2. Light weighted and lower project cost;

3. High industrial production level and reusable;

4. Compliant with the international building standard;

5. Steel structure houses are widely used in industrial plants, warehouses, shopping malls, office buildings and residential buildings.

Structural system selection

For multi-storey steel buildings, when the aspect ratio of the building is less than 4:1, the steel frame is the main load-bearing structure. Its anti-side force system is mainly based on frame and support.

Plane layout and component design

The column spacing of multi-storey steel houses is generally 6m-12m.

The column is generally a box-shaped section column welded by steel plate.

The main beam is generally welded H-beam or hot-rolled H-beam. The span of H-beam frame is 6m-12m.

The secondary beam is generally a cold-rolled H-section steel with a narrow flange. The spacing of the secondary beams is 2m-3.5 m.

The column is vertically supported.

When the column layout is close to a square shape, the support may be arranged at the four corners and the middle portion; when the column layout is rectangle, the lateral support should be arranged at both ends and the middle portion, and the longitudinal support should be arranged in the middle portion.

Floor design

The floor is generally formed by pouring concrete on a steel decking to form a combined slab or a non-composite slab;

A stud connection is used between the steel decking and the steel beam.

The steel decking is not only used as a permanent formwork, but also as a lower part of the concrete slab, the tensile steel bar and the concrete work together to form a composite slab to withstand the floor load;

The non-composite slab steel decking is only used as a permanent formwork. Regardless of working with concrete, it is assumed that a composite floor is not formed, so it is called a non-combined floor.

Steel structure production line